Texas Instruments SLEU056 manual Setup the TAS5010−5112F2EVM With the Analog Line Input

Page 24

Setup the TAS5010−5112F2EVM With the Analog Line Input

3.2.1Start-up Sequence

1)Turn on the power supply/supplies. Follow the power-up and power-down sequence described in the Power Supply section. Observe that the green Power ON LED and the yellow No S/PDIF LED are lit.

2)Run the DCT software from the PC desktop if the DAP is activated (S320) and the attached cable is connected from J300 to the PC.

3)Turn on the CD/DVD player and play the test CD. Observe that the yellow No S/PDIF now is OFF.

4)Observe that digital audio is coming from the left and right speakers.

3.3Setup the TAS5010−5112F2EVM With the Analog Line Input

-Disable the UNLOCK warning from S/PDIF receiver (JMP130: shunts pin 2 and 3)

-Connect the TAS5010−5112F2EVM board and PC with the attached cable

-Connect the analog source to the analog input (J160)

-Power up the TAS5010−5112F2EVM board

-Enable the TAS3002 analog input with the DCT software

-Disable the TAS3002 digital input (both SDIN1 and SDIN2) with the DCT software

-The TAS5010−5112F2EVM board is ready to play with analog source

3.4Interfacing the Analog Line Output

The default is the analog line output (J170) active. The analog line output can be connected to analog tape recorders or analog amplifiers (e.g., a subwoofer).

3.5 Controlling the DAP With PC Software

Operating instructions for the DCT software are described in the Digital Audio Processor (DAP) Configuration Tool Operating Instruction user’s guide, which is located on the PurePath Digitalt Amplifier CD-ROM.

3-4

Page 23 Page 25
Image 24
Page 23 Page 25
Contents User’s Guide Important Notice Products ApplicationsEVM Important Notice EVM Warnings and Restrictions Read This First About This ManualRelated Documentation From Texas Instruments Part Number Literature NumberContents Figures TablesTAS5010−5112F2EVM Features IntroductionTopic TAS5010−5112F2EVM Features −1. Simplified TAS5010−5112F2EVM Block DiagramTAS5010−5112F2EVM Features Page Detailed Description of the EVM TopicBoard Overview MuteDescription of Jumper Settings Enable/Disable S/PDIF−MUTE JMP130Double-Speed Control JMP120 Default Jumper Positioins Description of Connectors1 S/PDIF Digital Audio Coaxial/RCA Input J100 2 S/PDIF Optical J101Pin No Description Analog Input Connector J160 Analog Output Connector J170Pin No Pin Description Net Name on Schematic PC and I2C Interface J300Loudspeaker Connectors J540, J541, J580, and J581 Power Supply ConnectorPin No Description Net Name at Schematic Reference Designator DescriptionDescription of Switches and Buttons Description of Indicators Power LED LED223Temperature Warning LED LED221 Protection Mode LED LED220 EVM Board Operation Power Supply Power the EVM by One Power SupplyPower the EVM With Two Power Supplies Load = 6 ΩSetup the TAS5010−5112F2EVM With the S/PDIF Input Equalizer EnableSetup the TAS5010−5112F2EVM With the Analog Line Input Interfacing the Analog Line OutputControlling the DAP With PC Software Start-up SequenceHints for Measurement of Performance
Top Page Image Contents