Texas Instruments SLEU056 manual Loudspeaker Connectors J540, J541, J580, and J581

Page 18

Description of Connectors

2.4.5Loudspeaker Connectors (J540, J541, J580, and J581)

All speaker connectors accept standard 4 mm plugs. Use of high quality plugs and speaker cable are recommended.

Table 2−3. Description of Loudspeaker Connectors

Reference Designator

Description

J540

Left speaker positive output terminal

 

 

J541

Left speaker negative output terminal

 

 

J580

Right speaker positive output terminal

 

 

J581

Right speaker negative output terminal

Caution

Both positive and negative speaker outputs are floating and may NOT be connected to ground (f.ex. through an oscilloscope).

2.4.6Power Supply Connector

Figure 2−6. Pin Numbers at PSU Connector (Top View)

4

3

2

1

Table 2−4. Description of PSU Connector

Pin No.

Description

Net Name at Schematic

1

Supply voltage for output stage

POWER−OUTPUT−STAGE

 

(VHBR)

 

 

 

 

2

Supply voltage for control and gate

 

drive (V+)

 

 

 

 

3

Ground

GND

 

 

 

4

Ground

GND

2-6

Image 18
Contents User’s Guide Important Notice Products ApplicationsEVM Important Notice EVM Warnings and Restrictions Read This First About This ManualRelated Documentation From Texas Instruments Part Number Literature NumberContents Figures TablesTAS5010−5112F2EVM Features IntroductionTopic TAS5010−5112F2EVM Features −1. Simplified TAS5010−5112F2EVM Block DiagramTAS5010−5112F2EVM Features Page Detailed Description of the EVM TopicBoard Overview MuteDescription of Jumper Settings Enable/Disable S/PDIF−MUTE JMP130Double-Speed Control JMP120 1 S/PDIF Digital Audio Coaxial/RCA Input J100 Default Jumper PositioinsDescription of Connectors 2 S/PDIF Optical J101Pin No Pin Description Net Name on Schematic Pin No Description Analog Input Connector J160Analog Output Connector J170 PC and I2C Interface J300Pin No Description Net Name at Schematic Loudspeaker Connectors J540, J541, J580, and J581Power Supply Connector Reference Designator DescriptionDescription of Switches and Buttons Temperature Warning LED LED221 Description of IndicatorsPower LED LED223 Protection Mode LED LED220EVM Board Operation Power the EVM With Two Power Supplies Power SupplyPower the EVM by One Power Supply Load = 6 ΩSetup the TAS5010−5112F2EVM With the S/PDIF Input Equalizer EnableControlling the DAP With PC Software Setup the TAS5010−5112F2EVM With the Analog Line InputInterfacing the Analog Line Output Start-up SequenceHints for Measurement of Performance