Technicolor - Thomson RR420CD manual Operating the Alarm, Setting the Wake Time

Page 9

Operating the Alarm

EN

Setting the WAKE Time

Your digital clock operates on a 24 hour standard mechanism.

1.Press the SET button until ALARM 1 / ALARM 2 icon is blinking.

2.Press REV or FWD to set the wake time. The time decrements or increments will follow by a faster rate when you press and hold either REV or FWD .

3.After the ALARM time is set, press SET repeatedly until no icon is blinking.

Tip:

The unit equips with GRAD-U-

WAKE feature, the alarm tone volume will increase gradually to its maximum in about 30 to 45

seconds.

Tip:

If you set the SLEEP function

with low volume level before going to bed, we advise using ALARM mode to wake you up since its

volume will automatically increase.

Waking by Selected Source

You may be woken up by ALARM , RA- DIO or CD .

1.Select an MW or FM station.

2.Set wake time (see above directions).

3.Press ALARM 2 or ALARM 1 to select

waking up by ALARM , RADIO or CD . Corresponding indicator will be up next to the selected setting.

4. Adjust the volume by turning VOLUME.

You can select your CD wake track by the following procedures.

1.Press WAKE UP CD TRACK.

2.While pressing, press REV or FWD to select your desired CD wake up track.

Note:

When you turn off the alarm by pressing OFF, the alarm will turn on at the same time tomorrow.

7

Image 9
Contents Page Main Connections For UK only Vorsicht Safety InformationTechnical Specifications Before you begin Power Failure IndicatorOperating the Clock Setting timeOperating the Radio Tuning the StationsBuilt-In AFC AntennasListening to compact disc Selecting play modeOperating the Alarm Setting the Wake TimeWaking by Selected Source Turning off Alarm Sleep ModeNap Mode Operating the Clock RadioSnooze Alarm Operation Seconds Time DisplayBrightness control