Tascam HD-P2 Set System Time, Power Management, Audio Clock Management, Media Management

Page 18

HD-P2 Screens and Menus

Continued from the previous page

Set System Time

Figure 21 shows the current time stored in the real- time clock chip of the HD-P2. A backup lithium bat- tery powers this clock. The screen shows the status of this battery.

Figure 21 - Set System Time Screen

Power Management

Figure 22 shows the power readings screen. This information screen shows the state of the HD-P2 power system. It reports on the current voltage lev- els of the three sources of power for the HD-P2. The FireWire Voltage level should be between 8 and 40 Volts, although some FireWire adaptors may not pro- vide power. The Battery Voltage should nominally be above 10 volts and the batteries should be replaced if below eight. The provided AC adaptor provides approximately 12 VDC.

The voltage readings for FireWire and battery will read higher when they are not being used to power the HD-P2. This is because there is no load on them. The HD-P2 automatically switches between AC and

Figure 22 - Power Reading Screen

FireWire when both are present, preferring the higher voltage source.

Audio Clock Management

The HD-P2 supports a number of internal and external clocking options. Figure 23 shows the current sample rate along with the values of any external signals, and the measured deviance between their values and what the HD-P2 expects.

Whenever there is an error with a clock source falling out of spec the HD-P2 shows [error] next to the item. The Clear Alerts option is used to clear these errors.

Figure 23 - Audio Clock Information Screen

Media Management

This screen shown in Figure 24 provides tools for checking media useage and formatting/erasing CF media.

Figure 24 - Media Management Screen

Continued on the next page

18 TASCAM HD-P2 Owner's Manual

Image 18
Contents HD-P2 Important Safety Precautions Appliance to Rain or MoistureImportant Safety Instructions TrademarksTable of Contents Document Conventions Supplied accessoriesIntroduction About this manualSystem Organization File System Format Keys Transport Keys and Hold SwitchHD-P2 Interface Menu keys and Shuttle/Data wheelLeft Side Audio Switches, Inputs & OutputsAudio Switches Right SidePower Setup Operation Playing Audio HD-P2 Playback ConsiderationsMedia Space and Recording Audible Alerts HD-P2 Screens and MenusMonitoring Operational ScreenProject Menus Project Settings MenuMenu Navigation Main MenuSample Width 16 or 24 bits Project Files Menu Project Trash ManagerSystem Settings System MenusChange/New Project Audio Clock Management Power ManagementSet System Time Media ManagementMedia Speed Check Media CleanupMedia Information Reformat MediaProject Templates Software UpdateDefault Project Settings Display MenuOverview Timecode SettingsTimecode Clock SourceFreeWheel Trigger ModeRate Pull Up/Down Jam SyncShifted Menu Keys Key ShortcutsShortcuts Shifted Stop KeysExternal PS/2 Keyboard Equivalents External PS/2 Keyboard EquivalentsCompact Flash Card Layout FireWire DockDocking and Conforming HD-P2 Conform ApplicationDimensional Drawing HD-P2 Conform Application ScreensSpecifications SpecificationsHD-P2