NX-6A (Powered Near Field Studio Monitor)
Names and functions
1. Power LED
Lights when power is turned on.
2. Output level control Adjusts output level.
1 3. Tweeter level control
Adjusts tweeter level within a +/- 3dB range.
4.
2
3
4
5
6
Adjusts low frequency characteristics (around 55Hz range) within a +/- 3dB range.
5.Unbalanced input terminal (Phone jack)
Accepts
6.Balanced input terminal
Accepts +4dBu balanced input (hot pin is #2).
<CAUTION>: The balanced (XLR) and the unbalanced (phone) input connectors cannot be used simultaneously. When the unbalanced connector is plugged, the unbalanced input takes priority and the balanced input is disabled.
7
7. Heatsink
8
9
<CAUTION>: If you use the
8.Power switch
Turn the power on or off. Make sure that the output level control of the connected equipment is set to minimum when turning on the power.
9.AC IN connector
Connects the AC cord provided.
Level controls and EQ
VOL
0dB 
TWEETER
Output level control
Rotating the VOL control clock- wise increases the output level.
Tweeter level control
You can use the TWEETER con- trol to adjust the tweeter level within the range of +/- 3 dB.
The center position (0 dB) is the nominal position. Turning the control right boosts the tweeter level, while turning it left drops the level (see the graph right).
When the unit is shipped, the TWEETER control is set to the center (0 dB).
|
| Low (around 55Hz range) EQ | |||
0dB | LO EQ | You can use the LO EQ control | |||
| to boost/cut the low frequency | ||||
|
| ||||
|
| (around 55Hz range) within the | |||
+3 | range of | ||||
control right boosts the low fre- | |||||
|
| ||||
|
| quencies, while turning it left | |||
|
| cuts the low frequencies (see | |||
|
| the graph below). |
| ||
110 |
|
|
|
| |
| Wf +3dB |
| Tw +3dB |
| |
|
|
|
| ||
90 |
|
|
|
| |
| Wf |
| Tw |
| |
70 |
|
|
| ||
|
|
|
| ||
(dB) |
|
|
|
| |
50 | 50 100 200 | 500 1k 2k | 5k 10k 20k | 50k | |
10 20 (Hz) | |||||
6