ElectricalRequirements

Owner’s Manual	Room Air Heat Pump with R-410A	Heat Controller, Inc.

WARNING

Unpacking

UnpackingUnpack and visually inspect the unit. Report any damage to Unpackthe deliveringand visuallycarrier immediatelyinspect the. Ifunityour. Reportunit is notanydamaged,damage to remove and disgard all packing materials. On some models the delivering carrier immediately. Remove and discard all the air conditioner front and/or mounting kit hardware may be packing material. On some models the air conditioner front packed separately.

and/or mounting kit hardware may be packed separately.

Recordcordthethemodelmodel,andserialserialndnumbersanufacturingof your unitnumbersin the spaceof your unitprovidedin the. Thisspaceinformationprovidedisbelowfound. onThisa nameplateinformationvisibleis foundafteron athenameplatefront of thevisibleair conditionerafter thehasfrontbeenofremovedthe air conditioner. The rated has beenvoltage,removedamperage. Theandratedcapacityvoltage,for youramperagespecificandmodelcapacitycan for also be found on this nameplate. Read the warranty packaged your specific model can also be found on this nameplate. with the unit. Register your unit and keep the warranty and a Read the warranty packaged with the unit. Keep the warranty copy of your sales receipt for future reference. You may also and a copy of your sales receipt for future reference. You may want to record in the space provided the date purchased and also want to record in the space provided the date purchased the selling dealer.

and the selling dealer.

OWNER'S PRODUCT IDENTIFICATION

MODEL NUMBER

SERIAL NUMBER

MANUFACTURING NUMBER

Owner's Name

Address

City State Zip

/ /

Date of Purchase

Authorized Dealer

Address

City State Zip

( )

Phone Number

WARNING

To avoid death, personal injury or property damage due to electrical shock:

•Observe all local codes and ordinances.

•Disconnect electrical power to unit before servicing.

•Ground appliance properly.

•Check with a qualified electrician if you are not sure this appliance is properly grounded.

•DO NOT ground to gas line.

•DO NOT ground to cold water pipe if pipe is interrupted by plastic, non-metallic gaskets, or other insulating (non-conducting) materials.

•DO NOT modify plug on power cord. If plug

does not fit electrical outlet, have proper outlet installed by qualified electrician.

•DO NOT have a fuse in the neutral or ground circuit. A fuse in the neutral or ground circuit could result in an electrical shock.

•DO NOT use an extension cord with this appliance.

•DO NOT use an adapter plug with this appliance.

•DO NOT pinch power cord.

•DO NOT REMOVE warning tag from power cord.

Grounding Instructions

This appliance is equipped with a three-prong grounding plug for protection against possible shock hazards. If a two-prong wall receptacle is encountered, the customer is required to contact a qualified electrician and have the two-prong wall receptacle replaced with a properly grounded three-prong wall receptacle in accordance with the National Electrical Code.

Room air conditioners are designed to operate according to requirements on the nameplate and as shown in Table 1. Fuse or circuit breaker ratings must be according to the fuse instruction label and as shown in Table 1. Do not plug models marked “Use on Single Outlet Circuit Only” into a circuit with another appliance or light fixture.

Receptacle Wiring

Receptacle wiring must be of adequate size for unit. Refer to unit identification plate for exact power requirements. Minimum size of wiring, based on power requirements, is:

Units up to 20 amps:	12 gauge
20–30 amp units:	10 gauge

LCDI or AFCI Power Cords

Underwriters Laboratories (UL) and the National Electric Code (NEC) now require power cords that sense current

leakage and be able to open the electrical circuit to the unit. In the