Heat Controller DVC/DVH SERIES manual Timer OFF, Direct, Swing, Follow ME

Heat Controller DVC/DVH Remote Controller

Functions

10TIMER OFF

Press the button to initiate the auto-off timer sequence. Each press will increase the auto-timer setting in

30 minutes increments. When the set time displays 10, each additional time the button is pressed it will increase the auto-timer setting in 60 minute increments. To cancel the auto-timer program, simply adjust the auto-off timer to 0.0.

11DIRECT

Press this button to direct the airflow by selecting the position of the louver on the unit. Each time the button is pressed the louver will open/close by 6° increments.

NOTE: If the louver moves in a position that could affect the cooling or heating (heat pump models only) of the air conditioner, the unit will alter the direction of the louver angle automatically.

12SWING

Press this button to start/stop the auto swing feature, which the louver oscillates up and down.

NOTE: If the louver oscillates or moves in a position that could affect heating (heat pump models only) or cooling of the air conditioner, the unit will automatically adjust the louver position.

13FOLLOW ME

Push this button to initiate the Follow Me mode. In follow me mode, the temperature sensor built into the remote control senses the room temperature in place of the sensor inside the indoor unit. This allows the remote control to control the temperature of the room where

it is present. This feature helps prevent temperature stratification. When in follow me mode, the remote control display will show the actual room temperature it senses.

14LED

Disables/Activates the indoor \Display. When pushing the button, the indoor screen is cleared, press it again to turn on the light of the display.

7