Preparations

Power supply

Using the AC / DC adaptor

Turn off the player before connecting the supplied adapter to it and the main power supply (as shown). The player must be turned off when the battery charges.

✔TIP

•The plug is a disconnect device and shall remain readily

operable.

•To avoid damage to the player, switch off before plugging or unplugging the AC adaptor.

Using the car adapter

Connect the supplied car adapter to the set and the car cigarette lighter outlet.

✔TIP

•To avoid damage to the player, switch off before plugging or unplugging the car adaptor.

•When connecting with car power (cigarette lighter) adaptor, be sure the input voltage of the adaptor is identical with car voltage.

•Make sure the temperature is below 35oC when the DVD player is con- nected to DC 16.0V in a car.

Powering your remote control

1Open the battery compartment. Remove the protective

plastic tab (first time users only).

2 Insert 1 x lithium 3V battery, type CR2025, then close the compartment.

CAUTION

-Batteries contain chemical substances, so they should be disposed of properly.

-Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

-Incorrect use of batteries can cause electrolyte leakage

and will corrode the compartment or cause the batteries to burst.

PREPARATIONS

-Remove the battery if the remote control is not to be used for a long time.

Connections

Connecting headphones

Connect the headphones into the p jack of your set.

Connecting additional equipment

•Turn off your set before connecting to any additional equip- ment.

•You can connect the player to a TV or an amplifier to enjoy

DVDs or karaoke.

AV OUT

Connect the desired device to this terminal directly (no setting needed in the DVD mode).

White

Red

Not supplied

AUDIO IN

Yellow

VIDEO IN

English