American Standard 1742 Series Electrical Diagram Read and Follow ALL Instructions, AIR Switch

ELECTRICAL INSTALLATION INSTRUCTIONS

All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other applicable codes.

WARNING:

When using electrical products, basic precautions should always be observed, including the following:

1.DANGER: RISK OF ELECTRIC SHOCK

Connect only to a circuit protected by a ground-fault circuit interrupter.

2.Grounding is required. The unit should be installed by a licensed electrician and grounded.

3.Install to permit access for servicing.

4.All building materials and wiring should be routed away from the pump body and heater (if equipped).

The whirlpool should be installed on a 120 vac, 15 amp dedicated circuit. The circuit should be hard-wired from the electrical power supply panel. The circuit must be a three (3) wire circuit from the electrical supply panel. A grounded neutral wire and a third wire, earth ground, are essential.

ELECTRICAL INSTALLATION

SEPARATE 15 AMP GFCI

FOR 1.1HP MODELS

	120 VAC
	WHIRLPOOL MOUNTED
	AIR SWITCH
	or
	WALL TIMER
WHITE	BLACK
	PUMP/MOTOR
	GND.

ELECTRICAL DIAGRAM

READ AND FOLLOW ALL INSTRUCTIONS

753571-100 (3)