Heat Controller EKTH, EKTC manual Obtaining Service, Normal Operating Sounds and Conditions

Page 17

Obtaining Service

In the event this unit requires repair or servicing beyond what is covered in this manual, contact an authorized service organization.

To obtain an authorized servicer, contact your sales representative or agency.

Normal Operating Sounds and Conditions

Water trickling sounds

Water is picked up and distributed over the coil. This improves the efficiency and helps with water removal.

Water dripping

Water will collect in the base pan during high humidity days. This can cause overflow and drip from the outside of the unit.

Air sounds

The fan cycle switch sets the operational mode of the fan in the ON position. The fan will run continuously whenever power is applied in this mode. In the AUTO position, the fan will cycle on and off with the compressor or electric heater.

Starting delay

You may notice a few minutes delay in the starting if you try to restart the unit too soon after turning it off or if you adjust the thermostat right after the compressor has shut off. This is due to a built in delay to protect the compressor.

16

Image 17
Contents EKTC/EKTH Package Terminal AIR CONDITIONER/HEAT Pump Recognize this Symbol AS a Safety Precaution Lcdi power Cord Unit FeaturesTouch Pad Control Panel Chassis FrontEnergy Management System Features Transportation Damage Unit AccessoriesSleeve Stiffener and Rear Closure Panel Removal Installation InstructionsProper Sleeve Tilt Chassis Installation ViewCabinet Front Removal View Front Mounting ScrewHeaterless Units WiringPtac Wire Harness KIT PWHK01C Operating Instructions Power Cord RequirementsOperating Voltage User ControlsControl Board User Inputs Maximum Wire Length for Front Desk SwitchFront Desk Switch Wiring Schematic Vent Door Lever Positions Low Voltage Wires RoutingVent Control Lever Discharge Grille Orientation OptionsRemote Thermostat Remote Control InputsDischarge Air Flow Grille Removal Maximum Wire Length for Remote Control Connection Wiring Schematic for Straight Cool UnitWiring Schematic for Remote Heat Pump Monthly Maintenance and Cleaning Maintenance and CleaningIntake Filter Removal Vent Left Side UnitCabinet Front Yearly Maintenance and CleaningNormal Operating Sounds and Conditions Obtaining ServiceTo exit configuration mode Configuration SettingsDiagnostic Status Report Mode Diagnostic Maintenance & Status ReportOperating Temperatures Active FailuresDiagnostic Codes 12/06

EKTC, EKTH specifications

The Heat Controller EKTH and EKTC models are advanced heating solutions designed to provide energy-efficient climate control for residential and commercial spaces. These heat pumps combine sophisticated technology with user-friendly features to create a comfortable environment regardless of the outside temperature.

One of the standout features of both the EKTH and EKTC units is their inverter technology. This technology allows the compressor to operate at variable speeds, adjusting its output according to the current heating requirements. As a result, these systems provide consistent heating while consuming less energy compared to traditional fixed-speed units. The inverter technology not only enhances efficiency but also minimizes noise levels, making these heat controllers suitable for quiet environments.

Another significant characteristic of the EKTH and EKTC models is their all-weather performance. These heat pumps are engineered to perform effectively in a wide range of temperatures, ensuring reliable heating even in extremely cold conditions. With advanced defrost technology, these units can operate efficiently without freezing, maintaining optimal performance year-round.

User convenience is also a priority with the EKTH and EKTC systems. Both models feature intuitive digital controls that enable users to set their desired temperature comfortably. Additionally, many versions include Wi-Fi connectivity, allowing for remote access and control through a smartphone app. This feature is ideal for individuals seeking to monitor or adjust their heating systems while away from home.

Energy efficiency is a key aspect of the EKTH and EKTC heat controllers. They are designed with high Seasonal Energy Efficiency Ratios (SEER) and Heating Seasonal Performance Factors (HSPF), which indicate their effectiveness in converting energy into heated air. Energy Star certification is often achieved by these models, making them attractive options for energy-conscious consumers looking to reduce their carbon footprint.

With a compact design, the EKTH and EKTC units can be easily integrated into various settings without taking up much space, allowing for flexible installation options. The sleek aesthetic also ensures that they blend seamlessly with interior decor.

In summary, the Heat Controller EKTH and EKTC models represent a cutting-edge solution to heating needs. They combine inverter technology, all-weather performance, user-friendly features, and high energy efficiency to provide reliable and comfortable heating solutions for any environment. Whether for a home or a commercial space, these heat pumps deliver quality and convenience in climate control.