TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Do not open the set as there is a risk of electric shock! Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.
No sound /power
–Volume not adjusted
• Adjust the VOLUME
–Power cord not securely connected
• Connect the AC power cord properly
–Batteries flat / incorrectly inserted
• Insert (fresh) batteries correctly
–Headphones connected to the set
• Disconnect headphones
–Electrostatic discharge/interference
•Unplug the set. If batteries inserted, remove batteries from the battery compartment.. Press and hold STANDBY ON y for 10 seconds, then
•When in USB PC LINK mode, check that your PC's volume is audible and not set to minimum.
•When playing a CD from the PC's
Severe radio hum or noise
–Electrical interference: set too close to TV, VCR or computer
• Increase the distance
Remote control does not function properly
–Batteries flat/ incorrectly inserted
• Insert (fresh) batteries correctly
–Distance/ angle between the set too large
• Reduce the distance/ angle
Poor radio reception
–Weak radio signal
• FM: Adjust the FM telescopic antenna
indication
–No CD inserted
• Insert a suitable disc
–CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
–Laser lens steamed up
• Wait until lens has cleared
The CD skips tracks
–CD damaged or dirty
• Replace or clean CD
–SHUFFLE or PROG is active
• Switch off SHUFFLE / PROG
is displayed in USB PC LINK mode for more than 10 sconds
•Check the connection between your PC and the set. If necessary, please refer to the chapter Connecting to USB PC Link for the initial setup required.
•Make sure the connected PC is turned on and the MusicMatch software is working.