Philips AX5203, AX5210, AX5208, AX5201 Power Supply / General Information, Controls / Power Supply

Page 4

English

CONTROLS / POWER SUPPLY

CONTROLS ( see figure 1 )

1LINE OUT/p........3.5 mm headphone socket, socket to connect the player to another audio input of an additional appliance, remote control socket (not on all versions)

2

2;

switches the player on, starts or pauses CD play

3

skips and searches CD tracks backwards

4

§

skips and searches CD tracks forwards

5 MODE

selects the different playing possibilities: shuffle,

 

 

shuffle repeat all, repeat, repeat all and SCAN

6 PROGRAM

programs tracks and reviews the program

7

............................

display

8

9

stops CD play, clears a program or switches the player off

9 DBB

switches the bass enhancement on and off. This button also

 

 

switches acoustic feedback (the beep) on/off when it is pres-

 

 

sed for more than 2 seconds

0 VOL +/−

adjusts the volume

! 4.5V DC

socket for external power supply

@ OPEN 2

opens the CD lid

#ESP ON / OFF .....ELECTRONIC SKIP PROTECTION ensures continuous CD playback regardless of vibrations and shocks

$ OFF

switches RESUME and HOLD off

RESUME

stores the last position of a CD track played

HOLD

locks all buttons

%

typeplate

^

battery compartment

&

AAA battery door

This set complies with the radio interference requirements of the

European Union.

Batteries (supplied or optionally available)

You can use the following batteries with this CD-player:

alkaline batteries type AAA (LR03, UM4) or AA (LR6, UM3) preferably Philips.

Notes:– Old and new or different types of batteries should not be combined.

Remove batteries if they are empty or if the player is not going to be used for a long time.

Inserting AAA (LR03, UM4) or AY 3363 batteries

 

 

 

 

1 Open the AAA battery door.

+

 

 

 

2 Insert AAA batteries as shown onto the back of the

 

 

+

 

AA

/UM4

door.

 

 

 

03/A

 

 

3 Replace the battery-loaded AAA door back onto the

LR

 

 

 

 

-

 

 

set.

 

 

 

 

Inserting AA (LR6, UM3) batteries

AAA (LR03, UM4)

 

 

 

 

 

 

To double playback time, insert AA batteries into the bat-

 

 

 

 

tery compartment and use the AA marked battery door.

-

-

+

 

• Open the battery compartment and insert either 2

 

+ LR6 / UM3

 

 

 

 

AA SIZE

 

 

 

normal or alkaline batteries.

Battery indication

AA (LR6, UM3)

The approximate power level of your batteries is shown in the display.

Battery full

Battery two-thirds full

Battery one-third full

Battery dead or empty. When the batteries are dead

or empty, the symbol flashes, NO bAtt is displayed, and the beep tone sounds repeatedly.

POWER SUPPLY / GENERAL INFORMATION

Average playing time of batteries under normal conditions

Battery type

ESP on

Power Save

Normal AA

5 hours

9 hours

Normal AAA

 

3 hours

5 hours

Alkaline AA

 

18 hours

33 hours

Alkaline AAA

 

8 hours

15 hours

Rechargeable ECO-PLUS NiMH battery

7 hours

12 hours

Batteries contain chemical substances, so they should be disposed of properly.

ECO-PLUS NiMH battery information (for versions supplied with the

rechargeable ECO-PLUS NiMH battery AY 3363)

Recharging works only on players supplied with the rechargeable ECO-PLUS NiMH battery AY 3363.

Recharging the ECO-PLUS NiMH battery on board

1Insert the rechargeable ECO-PLUS NiMH battery AY 3363.

2Connect the mains adapter to the 4.5V DC socket of the player and then to the wall socket.

y is pulsing.

Recharging stops after a maximum of 7 hours, or

when you start playback.

3 When the battery is fully recharged, and FULL appears in the display.

Notes: – It is normal for the batteries to become warm during recharging.

If the batteries become too warm, recharging will be interrupted for approximately 30 minutes .

To ensure proper recharging on board, take care that contacts are clean.

Use only the ECO-PLUS NiMH battery AY 3363.

Handling instructions

Recharging already charged or half-charged batteries will shorten their lifetime. We therefore recommend that you let the rechargeable ECO-PLUS NiMH battery run till it is completely empty before you recharge it.

To avoid a short circuit, do not let the battery touch any metal object.

If the battery becomes empty soon after recharging, then either its contacts are dirty or it has reached the end of its lifetime.

Mains adapter (supplied or optionally available)

Use only the AY 3170 adapter (4.5 V / 300 mA direct current, positive pole to the center pin). Any other product may damage the player.

1Make sure the local voltage corresponds to the power

adapter’s voltage.

4. 5VDC

2Connect the power adapter to the 4.5V DC socket of the player and to the wall socket.

Note: Always disconnect the adapter when you are not using it.

Environmental information

• All redundant packing material has been omitted. We have done our utmost to make the packaging easily separable into two mono materials: cardboard (box) and polyethylene (bags, protective foam sheet).

• Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment.

Image 4
Contents AudioAudio Page Quick Start VOLPower Supply / General Information Controls / Power SupplyGeneral Information Features FeaturesTroubleshooting Troubleshooting No sound or bad sound qualityIndication no dISC is displayed Indication NF dISC is displayedMeet Philips at the Internet 3140 115 2985