Philips AD7000W/37 Connect to your home Wi- Fi network for AirPlay, See ‘Turn AD7000W on’ on

4Connect to your home Wi- Fi network for AirPlay

To connect AD7000W to your existing home Wi-Fi network, you need to apply your home Wi-Fi settings to AD7000W.

You can do this in two ways (depending on which type of Wi-Fi router you use):

•Automatically - if your Wi-Fi router is WPS (Wi-Fi Protected Setup)- enabled and supports PBC (Push Button Connection) (see ‘Scenario 1: Connect to a WPS router’ on page 13)

•Manually - if your Wi-Fi router does not support WPS (see ‘Scenario 2: Connect to a non-WPS router’ on page 14)

Once connected successfully, AD7000W will remember your home Wi-Fi settings.Then you can enjoy AirPlay whenever AD7000W is powered on and connected to your home Wi- Fi network automatically.

Before connection of AD7000W to you home Wi-Fi network, check the points below.

1	Make sure that your Wi-Fi router is
2	powered on and working properly.	ng l i s h
	Make sure that AD7000W has been
	powered on and booted up successfully	E
3	(see ‘Turn AD7000W on’ on page 12).
	Identify the type of your Wi-Fi router (see

the user manual of your Wi-Fi router for details).

Scenario 1: Connect to a

WPS router

Note

•• Before you press any button on AD7000W, make sure that AD7000W has been booted up successfully (see ‘Turn AD7000W on’ on page 12).

1 Press the WPS button on your home Wi-Fi router.

WPS

2 Shortly after step 1, press Wi-Fi SETUP on the back of AD7000W.

»» The Wi-Fi SETUP indicator blinks red, yellow and green alternately.

»» Within 2 minutes, the WI-FI SETUP indicator stops blinking and stays green, and the unit beeps.

»» AD7000W is connected to your home Wi-Fi network successfully.

EN 13