Philips AD7000W/37 user manual Switch AD7000W to Assisted Wi-Fi Setup mode

2 Launch the Internet browser (for example, Apple Safari or Microsoft Internet Explorer) on your Wi-Fi enabled device.

3 Open the configuration page of your home Wi-Fi router.

4 Find the Wi-Fi settings tab and write down the following information on paper:

A Network name (SSID)

BWi-Fi security mode (usually WEP, WPA or WPA2 if enabled)

CWi-Fi password (if Wi-Fi security is enabled)

DDHCP mode (enabled or disabled)

EStatic IP address settings (if DHCP mode is disabled)

Switch AD7000W to Assisted Wi-Fi Setup mode

Note

•• Before you press any button on AD7000W, make sure that AD7000W has been booted up successfully (see ‘Turn AD7000W on’ on page 12).

•Press and hold Wi-Fi SETUP on the back of AD7000W for more than 5 seconds. »» The Wi-Fi SETUP indicator blinks

green and yellow alternately.

»» A new Wi-Fi network created by
AD7000W will appear, with the	i s h
network name (SSID) of Philips Fidelio
AirPlay.	E n g l
»» It may take up to 45 seconds for
successful creation of this new Wi-Fi
network.

Note

•• After you finish manual Wi-Fi setup for AD7000W, the new Wi-Fi network created by AD7000W will disappear.

•• If you fail to enter Assisted Wi-Fi Setup mode, power off AD7000W and power on it, then try again after successful boot-up.

•• Make sure that there are no other Philips AirPlay- enabled devices in Assisted Wi-Fi Setup mode at the same time. Multiple Wi-Fi networks created this way may interfere with each other.

Connect your Wi-Fi enabled device to the newly created Wi-Fi network

The new Wi-Fi network created by AD7000W only allows access of one Wi-Fi enabled device. To avoid interference from any other Wi-Fi devices, you are recommended to temporarily disable the Wi-Fi function on your other Wi-Fi devices.

 

Option 1: Use your iPod touch/iPhone/iPad

1 Select Settings -> Wi-Fi on your iPod touch/iPhone/iPad.

EN 15