Philips DC350 Product information, Set the sleep timer, Adjust display brightness, Specifications

•Press POWER.

»The alarm timer remains activated.

•Press REPEAT ALARM on the main unit.

»The alarm call repeats at 9-minute intervals.

•Press ALM 1 or ALM 2 on the main unit.

»[AL 1] (alarm 1) or [AL 2] (alarm 2) disappears from the display.

»The alarm timer is deactivated.

Set the sleep timer

This DC350 can switch to standby automatically after a set period of time.

1When the DC350 is turned on, press SLEEP repeatedly to select a set period of time (in minutes).

» When sleep timer is activated, the display shows .

To deactivate sleep timer

1Press SLEEP repeatedly until “0” is displayed.

» When sleep timer is deactivated, disappears on the display.

Adjust display brightness

1Press repeatedly BRIGHTNESS CONTROL on the main unit to select:

•Bright.

•Dim.

•Off.

9 Product information

Note

•Product information is subject to change without prior notice.

Specifications

Amplifier

Rated Output Power	2X3W RMS
Frequency Response	125Hz - 16kHz, ±3dB
Signal to Noise Ratio	>65dB
Aux Input	0.6 V RMS 10kohm

22EN