Haier AD42NAHBEA Malfunction, Unit fails to start, Cooling or heating is not sufficient

Page 8

Malfunction

please check the following things about your air conditioner before making a servie call.

Unit fails to start

Is the power source switch adjust cut in?

ON

OFF

Power supply switch is not ON.

Is city supply power in

Isn't the signal receiving

Isn't the earth leakage

normal?

section exposed to the

breaker in action?

 

direct sunlight or strong

 

 

illumination?

It is dangerous. Turn off

 

 

Power

 

the power supply switch

stoppage?

 

immediately and contact

 

 

 

 

the sales dealer.

Cooling or heating is not sufficient

Is the thermostat adjust Isn't the air filter dirty?

Isn't any doors or windows

Doesn't any obstacle

as required?

left open?

exist at the air inlet or

 

 

outlet?

 

 

 

Isn't the swing louver

Cooling is not sufficient

 

horizontal?

 

 

 

Isn't sun-shine invading

Isn't any unexpected

Isn't the room much

(At HEATING mode)

If swing louver is horizontal,

direct?

heating load generated?

crowded?

the blow wind does not reach

 

 

 

floor.

 

 

 

The wind does not blow

 

 

 

 

 

 

during heating operation

 

 

 

Isn't it warming up?

 

 

 

When the air conditioner does not operate properly after you have checked the above mentioned items or when the following phenomenon is observed, stop the operation of the air conditioner and contact your sales dealer.

The fuse or breaker often shuts down.

Water drops off during cooling operation.

There is a irregularity in operation or abnormal sound is audible.

When the CHECK LED1 (red) flickers, an irregularity has occurred in the air conditioner.

7

Image 8
Contents Duct Type AIR Conditioner Table of Contents Disposal of the old air conditioner Safety Precations Make sure the system is groundedSafety Precautions Make sure to use a fuse of proper electric ratingMachine is adaptive in following situation Parts and Functions Malfunction Unit fails to startCooling or heating is not sufficient Cooling is not sufficientFollowings are not malfunction Care and Maintenance Points to observeFor Preparation of HeatingHot Keep HOT KEEPis operated in the following casesIs The Unit Installed Correctly Installation placeWhen you change your address or the installation place For inspection and maintenanceInstallation Manual For Indoor Unit Section as wellChoose installation place Height of ceilingPreparation before installation AD36NAHBEA AD42NAHBEA AD52NAHBEAInstallation of indoor unit Adjusting to the levelnessDrain Piping Good pipingDrainage Test Installation of air suction and discharging ductProcedures M3/hm3/n Mmxmm Chosen chart of simple ductMmxmm Examples of improper installation Rotate this switch Operation method of fan controllerRefrigerant pipe Power Supply 1PH,220-230V~,50Hz Installation Manual For Electric WiringWiring connection