![](/images/new-backgrounds/1007345/73459x1.webp)
Operation
Timer On/Off On-Off Operation
1.After unit starts, select your desired operation mode.
2.Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as follows: Remote controller:
BLANK
0.5h | 0.5h | 0.5h | 0.5h |
TIMER ON | TIMER OFF | TIMER | TIMER |
Then select your desired TIMER mode (TIMER ON or
TIMER OFF or TIMER "or "
"will flash.
3.Press /
button to set time.
Press the button for each time, setting time in the first 12 hours increased by 0.5 hour every time, after 12 hours,increased by 1 hour every time.
Press the button for each time, settiing time in the first 12 hours decreased by 0.5 hour every time, after 12 hours,decreased by 1 hour every time.
It can be adjusted within 24 hours.
4.Confirm timer setting
After adjust the time,press | button and confirm the |
time ON or OFF button will not flash any more.
5.Cancel timer setting
Press the timer button by times until the time display eliminated.
Hints:
After replacing batteries or a power failure happens, time setting should be reset.
According to the Time setting sequence of TIMER ON or
TIMER OFF, either
Health airflow Operation
1.Press ![](/images/new-backgrounds/1007345/73459xi12.webp)
![](/images/new-backgrounds/1007345/73459xi13.webp)
![](/images/new-backgrounds/1007345/73459xi14.webp)
![](/images/new-backgrounds/1007345/73459xi15.webp)
![](/images/new-backgrounds/1007345/73459xi16.webp)
![](/images/new-backgrounds/1007345/73459xi17.webp)
![](/images/new-backgrounds/1007345/73459xi18.webp)
to starting
Setting the comfort work conditions.
2.The setting of healthy airflow function
Press button to select “ Healthy airflow”, the remote
controller will switch as below
Healthy | Healthy | fixed |
| |||
airflow |
| airflow |
|
| ||
upwarder | downwarder | location | ||||
|
|
Notice: Do not direct the flap by hand. Otherwise, the grille will run incorrectly. If the grille is not run correctly,
stop for a minute and then start, adjusting by remote controller.
Note:
1.After setting the healthy airflow function, the position grill is fixed.
2.In cooling, it is better to select the |
| mode. |
|
3.In cooling and dry, using the air conditioner for a long time under the high air humidity, condensate water may occur at the grille .
5