COBY electronic instruction manual Preparing the CR-A149 for Use

Page 11

GETTING STARTED

Preparing the CR-A149 for Use

Plug the clock into an AC 120V outlet.

Press the RESET button located on the rear of the clock. Upon reset- ting the clock:

The display will light up and flash

The temperature will be displayed for 4 seconds

The remote unit will search for the 433MHz transmission signal in 5 minutes

The main unit will start searching for the RCC (Radio Controlled Clock) signal automatically. The RCC signal will synchronize your clock’s time and date (including Daylight Savings Time).

An animated antenna dish icon indicates that the unit is search- ing for a signal.

The antenna dish icon indi- cates that a signal has been received.

The unit will stop searching after 10 minutes if a signal cannot be received

It will take up to 10 minutes for the signal to synchro- nize the clock time.

RCC synchronization may be turned on or off by holding the snooze button for 3 seconds.

For best results, place the RCC antenna near a win- dow with a clear view of the sky. Keep the RCC an- tenna away from metal or electrical objects.

www.cobyusa.com

Page 11

 

 

Image 11
Contents CR-A149 For Customer Use PrecautionsImportant Safety Instructions Important Safety Instructions Important Safety Instructions Table of Contents Features Rear View Getting StartedCR-A149 at a Glance Top View Front ViewRight View Left View Reset Power Connection AC PowerBattery Backup Preparing the CR-A149 for Use Setting the Clock Time and Date CLOCK/ALARM ModeSetting the Alarm Timer Snooze Function Turning the Alarm Timer On/Off Alarm ModeSetting the Sleep Timer Wireless Outdoor Temperature Sensor Temperature ReadingIndoor Temperature Outdoor TemperatureTemperature Reading Projection System Reception Radio ModeTuning Basic OperationCoby Electronics Technical Support TroubleshootingWwvb SpecificationsCoby Electronics Corporation Page Coby Electronics Corp