made, then the current settings are activated and the device goes back into automatic operation.
is made within 15 seconds, the device shows the frequency if the radio is on, or if not, the time again.
2.5 Checking the world time
• | Press »MODE« | four times if the device is in time |
| display mode. |
|
• | Press »MODE« | five times if the device is in radio |
| mode. |
|
•If the device is already in "Setting the local time" mode as described in Section 2.4, you can enter "Checking the
world time" mode by pressing the »MODE« button once.
•The last time zone is displayed steadily in the hours and minutes part of the display, while on the right the code for the appropriate city starts to flash. The display shows "CITY" above steadily.
•You can select the required time zone by pressing the »UP« or »DOWN« buttons in accordance with the table in Section 2.4.
•Press »SNOOZE« to change the display. The display 'SUN' shows the remaining daylight.
• If »MODE« is pressed once, or if no further setting
2.6 Sleep Timer
• | Press »SLEEP/RADIO ON« | once to check the sleep |
| timer current setting. If the Sleep Timer is not activated, | |
| then the display briefly shows "ON" (radio switched on). | |
• | Press »SLEEP/RADIO ON« | once again to change the |
| current setting. (in decrements of 10 minutes, from 90- | |
| 10 minutes). The radio remains switched on and the | |
| selected band appears in the lower area of the LCD. | |
• | Press »SLEEP/RADIO ON« | when the display reaches |
desired number of minutes/duration for the Sleep Timer (e.g. "10" for 10 minutes). "OFF" switches off the radio.
•If within 15 seconds there has been no further setting made, then the current settings for the Sleep Timer are activated and the device goes back into automatic operation.
2.7 Setting ALARM 1 and ALARM 2
• Press the »AL. 1« or »AL. 2« button once. 'AL 1' or 'AL 2' is displayed steadily in the alphanumeric
10