the corresponding channel directly.
3) Screen display
Press DSP button on remote control or on docking station panel to display the current status such as TVch. If there is no operation for more than five seconds, the information on the screen will disappear.
Setting the Time
1) Setting the clock
Setting the Clock or Alarm Time (Home Dock must be powered on)
1) Setting the clock
Briefly press DSP button on docking station panel, the time display will appear on the home dock LCD display. Press SEL button once, the hour will flash. Press SEL button again the minute will flash. you can adjust the hour or minute's value while flashing by rotating the VOLUME knob clockwise or
2)Setting the alarm time Press and hold DSP button on the docking station panel will enter the alarm time setting mode. Like setting the clock, press SEL button to select hour or minute, then rotating VOLUME knob to adjust the hour or minute's value.
To cancel the alarm, just press and hold DSP button to open the alarm time, then press and hold DSP again to cancel.
[Alarm icon display is a bell just left of and above the AM/PM indicator of the home dock LCD display. Be sure icon is displayed or alarm will not function. The alarm must be set every time you need to use it. It will not automatically repeat.]
Note:
a. When alarming, press any button (except the VOLUME knob) to stop alarming.
b. When alarming, Press SNOOZE (VOLUME) button will stop alarming for three minutes. After three minutes will alarm will sound again. (NOTE: This will only function once and the alarm time will be moved forward by 3 minutes.)
AUTO TURN ON (Can only be set while the home dock is powered off)
3)Auto turn on the docking station (wake to music) can only be set when the docking station is powered off. Briefly press DSP button on the home docking station panel to set the desired time to auto turning on the home docking station.
Be sure you have set the volume level and source selection (MODE) to the desired selections.
© 2006 Directed | 29 |