8.Press the MEMORY button. The display will change to “New Code Confirmed”
•If you entered the code incorrectly, “Code Error” will be displayed, and the Enter New Lock Code screen reappears. Repeat Steps 5 – 8.
Startup Mode
You can select which screen is displayed when you turn Here2Anywhere’s power on.
1. While in the Setup Mode, press the left or right arrow button until the Startup Mode screen appears (right):
2. | Use the up & down arrow buttons to highlight the | Startup Mode Screen | |||||||
| screen you want for Startup: Normal Operation, |
|
|
|
|
| |||
| Channel List (Stream List) or Category List: |
|
|
|
|
| |||
3. | Press the |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| ||
| SELECT button. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Output Level |
|
|
|
|
| |
Normal Screen | Stream List Screen |
| Category List Screen | |||
You can adjust |
| |||||
|
|
|
|
| ||
Here2Anywhere’s output level so it matches other |
|
|
| |||
sources in your audio system. |
|
|
|
| ||
1. | While in the Setup Mode, press the left or right arrow |
|
|
| ||
| button until the Output Level screen appears (right): |
|
|
| ||
2. | Use the up & down arrow buttons to select the |
|
|
| ||
| desired output level. |
|
| Output Level Screen | ||
• “High” is 0dB, “Medium” is
Note: To avoid distortion with some cassette car stereos, you may have to lower the output level when using the cassette adapter.
Antenna Signal
This screen shows the quality of the SIRIUS satellite signal that’s being received, to help you find the best location for the antenna.
1. While in the Setup Mode, press the left or right arrow button until the Antenna Signal screen appears (right):
• After a few seconds the signal quality bars will |
| |
indicate how well the antenna is receiving the |
| |
SIRIUS satellite signal. | Antenna Signal Screen | |
2. Find a location for the antenna that illuminates the | ||
| ||
maximum number of bars. |
|
•After moving the antenna, wait at least 2 seconds before moving it again, to enable the unit to process the signal.
3.Due to the moving paths of the SIRIUS satellites, it is possible for the signal to change over time. In most cases, signal should be available continuously, however, it may be temporarily blocked in some antenna locations in home installations. Be sure to check the the Antenna Signal screen if there is a loss of signal or audio. Experimentation with antenna placement in the home or outside may be necessary to ensure continuous reception.
•See pg. 11, Step 5 for information about locating the SIRIUS antenna in a home installation.
24
Here2Anywhere Instruction Manual
Here2Anywhere Instruction Manual
25