Kenwood KTC-H2A1 instruction

Installation in a home with the KPA-H2H kit (available separately)

Note: Do not put Here2Anywhere in the docking station until you have completed the installation.

Installation in a home (continued)

1. Using the	provided	screw,	2A. Plug the audio	2B. Plug the audio
assemble the	docking	station	cable’s mini	cable’s white
cradle to the base.			connector into the	(L ch,) and red
			back of the	(R ch.) connectors
			cradle, as shown.	into your audio
				system.

3.Plug the AC cord into the power supply, then plug the power supply into the back of the cradle, as shown. Don’t plug the AC cord into a wall out- let until the installation is completed.

4.Plug the antenna into the back of the cradle until it is firmly seated, as shown.

5.Due to the paths of SIRIUS satellites over the US, the best location for the antenna in your home depends on where you live. Use the map below as a general placement guideline— some experimentation may be needed to obtain the best results. In major US cities, you may also be able to receive the signal from SIRIUS ground repeaters, which may allow you to place the antenna away from a window. In all cases, since the antenna is weather-proof if necessary you can also locate it outside, clear of any overhead obstructions. (This is especially important if your house has an extended roof or extended window frame struc- tures.) See pg. 25, Antenna Signal, for more information about using the ANTENNA SIGNAL screen to aim the antenna.

Section 1: Place the antenna at an EAST-FACING window

Section 2: Place the antenna OUTSIDE, away from any over- head obstructions

Section 3: Place the antenna at a WEST-FACING window

Section 4: Place the antenna at a NORTH- or EAST-FACING window

Section 5: Place the antenna at a NORTH-FACING window

Section 6: Place the antenna at a WEST- or NORTH-FACING window

1	2	3

4	5		6

Here2Anywhere Instruction Manual