Installing Your Speakers From The Front Of The Bulkhead
A 17
A 18
Remove the speaker cone shield from the enclosure.
Snap the grille in place on the mounting flange. No hardware is needed to secure this part. You are now finished with the assembly. Enjoy your music system!
BInstallation from the front of the bulkhead
If you cannot reach the mounting area from behind the bulkhead, you will have to mount the speaker enclosure by inserting it through the front. To do this you will need a 71⁄8 inch (18 cm) hole, the larger of the two perforated sections on your template.
CAUTION: Determine whether any obstacles exist behind the mounting surface. To be certain, contact your boat manufacturer or dealer. Also, be certain that the enclosure will fit within the mounting area before drilling any holes.
B 1 Place the template over the area where the speaker is to be located. The round outer edge shows how much room to allow for the grille. The long end is used to judge the room needed behind the bulkhead. There are two perforated circles in the template.
Snap out the larger one and mark the 71⁄8 inch (18 cm) hole with a metal scribing tool or pencil.
AM188201_02_V.pdf | October 30, 2001 | 11 |