Installing Your Speakers From The Front Of The Bulkhead
B 10
B 11
B 12
Tie a knot in each joined wire pair to protect the connection from being pulled apart.
Reinsert the enclosure into the wall in the position you determined in Step 7. If the outside circle of holes in the mounting flange line up with the ones you originally marked, remove the enclosure and drill at these marks. If they do not, make new markings that you can differentiate from your original set of markings.
Remove the speaker enclosure.
CAUTION: Do not drill while the speaker enclosure is in place.
B 13 Drill six 1⁄8 inch (.32 cm) holes.
B 14 Reinsert the speaker enclosure.
Note: For added protection against water enter- ing the bulkhead, you can apply a generic silicone sealant between the flange and the mounting surface.
14 | October 30, 2001 | AM188201_02_V.pdf |