Haier AB422BCBAA manual Set temperature

Operation instruction Auto/Cooling/Dehumidifying/Heating operation 1 Turn on the unit

2MODE FAN SWING

TEMP 4

3CLOCK 3 SET

SET TIMER SLEEP

HEAT FILTER RESET

RESET

5

ON/OFF

1

Press the ON/OFF button to turn on the unit The LCD display of the wire controller will show the previous working state (except for TIMER, SWING, SLEEP mode). The operation indicator light on the wire controller will light up.

2Choose of working mode

Press MODE button, each press the working mode will change as the following sequence:

AUTO COOLING DEHUMIDIFYING HEATING FAN

W h e n	r o o m
temperature is higher
than set temperature,
unit in	COOLING
operation.		Ultra-low air flow

Set temperature + 2*

Set temperature

When room temperature reaches set temperature

+2*, the unit will operate in mild dehumidifying operation.

In Heating operation, after start the unit, the air conditioner will sending warm air a moment later to prevent the cold air blowing out. In Dehumidifying, when the room temperature drops 2* higher than the set temperature, regardless the set fan speed, the air conditioner will intermittently operate in low fan speed.

then choose AUTO, COOLING, DEHUMIDIFYING, HEATING operation.

3Set temperature

Press the TEMP. SET button

*Each press , the set temperature will increase 1 degree.

*Each press, the set temperature will decrease 1 degree.

Set the desired temperature.

4Adjusting FAN SPEED

Press the FAN SPEED button, for each press, the fan speed will change as the following

sequence:AUTO

LOW FAN MED FAN HIGH FAN AUTO

Choose the desired fan speed.

5Turn off the unit

Press the ON/OFF button to turn off the unit.

The wire controller only shows the clock and room temperature.

Hints:

The wire controller can memorize the working condition of each time. When start the unit for the second time, just need to press ON/OFF button, the air conditioner will work according to the previous working mode. (except for Timer, Sleep and Swing)

8