Haier AB422BCBAA manual Refrigerant pipe, Installation of drain hose 1Install the drain hose

(use seal cushion to bind the pipe joint)

Clamp

Medium seal cushion (accessory)

Installation procedure

Install indoor unit

5.Refrigerant pipe

[The proper thermal insulation must be treated to gas pipe and liquid pipe. If not, it may cause water leakage.]

The outdoor unit is not charged with refrigerant.

When connecting the pipes to unit or dismantling the pipes from the unit, do proceed as the figure shown, use spanner and torque pincers together.

For the dimension of the cone-shaped screw nut, please referring to Table 1.

When connecting pipes, both the inner or the outside of the cone-shaped screw nut should pasted with refrigerant oil. Use hands to twist it for 3~4 circles, then tighten it.

According to Table 1 to confirm the fasten torque. (fasten too tight may damage the screw nut leading to leakage)

After check if the connection pipes leaks, then perform thermal insulation treatment, as the following figure shown.

Only use seal cushion to bind the joint between gas pipe and the insulation parts.

Paste refrigerant oil here

Torque spanner

Spanner	Thermal insulation part (accessory)
	(for liquid pipe)
Pipe joint	Thermal insulation part (accessory)
Cone-shaped screw nut	Gas pipe (for gas pipe)
	Liquid pipe

Specification of pipe	Torque	Dimension of cone		Cone
(mm)		A (mm)
*9.52	3270~3990 Ncm	12.0~12.4	45	2
				R0.4~0.8
	(333~407 kgf*cm)
			90	0.5
	9720~11860 Ncm
*15.88		18.6~19.0		A
	(990~1210 kg*fcm)

6.Installation of drain hose (1)Install the drain hose

The diameter of the drain hose should be larger than or equal to the diameter of connection pipe.

(Polyethylene pipe, dimension: 25mm, external diameter:32mm)