Bose AM267565 manual To test the speaker

Page 27

Steps to Installing

To test the speaker:

1.Turn on the receiver/ampliﬁer and play a piece of music that is familiar to you.

2.Listen for clarity and accuracy of the performance from one speaker.

•If you hear a problem, refer to “Troubleshooting” starting on page 32.

•If the performance sounds ﬁne, test the other speaker, or continue with the installation steps for this speaker.

When the connections are completed, push any excess wire into the hole behind the speaker (Figure 30).

Figure 30

Pushing excess wire behind the speaker

3.Make sure the frame of the speaker is ﬁrmly screwed onto the face. The frame prevents the speaker from slipping all the way into the hole. Refer to Figure 23 on page 22 if you need to reverse the frame to properly orient the Bose logo on the speaker face.

4.Now push the speaker into the hole until the face is straight and ﬂush with the wall (Figure 31).

Figure 31

Positioning the speaker all the way in the hole

Or

AM267565_01_V.pdf May 13, 2003

27

Image 27

Contents Bose Virtually Invisible 191 Speakers Important words of caution Safety InformationContents Introduction Before you beginWhat makes this speaker better also makes it different Preparation UnpackingOther equipment you’ll need Considering your wall type and the approach it requires Consider which shape you prefer for your speakersOptional items What to do when the room is not pre-wired Accessories that can helpInstalling in a pre-wired room How to determine pre-wiringDeciding on speaker placement Installing in an exterior wallSpecial considerations in cold climate regions Select the general wall area for one speaker For Cutting Prepare the cord Using speaker cordWire recommendations Planning to run speaker cordPreparation Before the wallboard goes up Where the walls are ﬁnishedGetting started Before you make any holes Steps to InstallingDrill a pilot hole for testing the wall space Using the template for this ﬁrst stepPilot hole Drilling the pilot hole Use the bent wire to test for enough depth, front-to-back Testing the space behind the holeChecking the space for the width of the speaker Passing the pilot hole test Repairing a pilot holePrepare the wall for inserting the speaker Using the template a second timeCutting the speaker hole If you encounter insulation behind the wall Insert and wire the speakerInsert the speaker into the opening Speaker held in place by wall stops Test the speaker now Make the speaker connectionsTo test the speaker Secure the speaker to the wall When the grille is ﬁnally in place Choosing to paint the speakersIf the speaker looks crooked Using a dry brush technique Using a spray techniquePainting the grille Steps for spray painting Painting the frameReference TroubleshootingCustomer service Warranty periodTechnical information Accessories