user manual
QLight™ series
Side-mounted flying strips can be fitted to the sides of TQ-445 enclosures by removing the countersunk bolts on the top and sides of the cabinet and replacing them with the M10 bolts supplied with the hardware. Two flying strips are required for each enclosure; one attached to each side. This method offers a simple and cost effective way of flying single enclosures in permanent installations. Enclosures may also be arranged in a vertical column by coupling the flying strips together using QL-75 quicklinks or shackles. Turbosound flying strips are individually load tested. When used in this way the load is taken through the flying strips rather than through the woodwork of the enclosure.
Side-mounted flying strips can be fitted to the sides of Qlight™ series subwoofer cabinets to enable subwoofer enclosures to be flown as part of a permanent installation. Two different lengths of flying strips are optionally available for flying the enclosure in either a vertical or horizontal orientation. These are fitted by removing the countersunk bolts on the top and sides of the cabinet and replacing them with the M10 bolts provided with the hardware. Two flying strips are required for each enclosure. This method offers a simple and cost effective method of flying single or multiple enclosures, with the load being taken through the steel strips rather than through the woodwork of the enclosure. Enclosures may be arranged in a vertical column if required by coupling the flying strips together using QL-75 quicklinks or shackles. Turbosound flying strips are load tested.
WARNING: Rigging eyebolts must not be used for flying this enclosure. You must use the optional Turbosound steel flying strips described above.
TQ series manual page 14
