Graco 309004C important safety instructions Equipment Misuse Hazard

Page 3

Warning Symbol

 

Caution Symbol

 

 

 

 

 

 

 

This symbol alerts you to the possibility of serious

This symbol alerts you to the possibility of damage

 

injury or death if you do not follow the instructions.

to or destruction of equipment if you do not follow

 

 

 

the instructions.

Equipment Misuse Hazard

Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.

This equipment is for professional use only.

Read all instruction manuals, tags, and labels before operating the equipment.

Use the equipment only for its intended purpose. If you are uncertain about usage, call your Graco distributor.

Other than for installation purposes do not alter or modify this equipment. Use only genuine Graco parts and accessories.

Check equipment daily. Repair or replace worn or damaged parts immediately.

Do not exceed the maximum working pressure of the lowest rated system component.

Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not expose Graco hoses to temperatures above 200 F (93 C) or below 0 F (-18 C).

Do not lift pressurized equipment.

Comply with all applicable local, state, and national fire, electrical and safety regulations.

3 309004

Image 3
Contents CycleFlo Pneumatic Pump Controller Table of Contents Equipment Misuse Hazard Fire, Explosion, and Electric Shock Hazard Installation General DescriptionElectrical Connections Pneumatic Connections Electrical DiagramsOutlet Port Exhaust Muffler Electric Shock Hazard Setup & AdjustmentAdjustment Cycles Per Minute CPM RateOperation TroubleshootingOperation Procedures Problem Possible Cause & RemedyParts Cycle rate adjustment relay Enclosure Air Solenoid ValvesCycleFlo II Controller Typical Installation DiagramController Technical DataMounting Hole Layout Graco Standard Warranty