6.Press and hold DTS button to clear error code to zero.
ti13614a ti13608a
7. Short press to move to SOFTWARE REV.
ti13623a |
ti13613a
8.Short press to display number of GUN TRIGGERS logged.
ti15694a | ti7362a |
9.Short press to enter BLOCK mode. Hold DTS but- ton in to block any active outside RF signals in the area other than the current learned controller. The screen will display the number of unwanted signals being blocked. Up to 5 unwanted RF signals can be blocked.
Setup
10.Short press to enter CLEAR mode. Hold in DTS button to clear all RF signals that were being blocked.
ti15693a
11.Short press to RF ON/OFF mode (this is used for Troubleshooting only). To turn RF off and enter pres- sure control mode, make sure flow control knob is at zero. Hold DTS button until screen displays RFOFF. Turn power switch OFF, then turn back ON. The dis- play will show an asterisk to indicate that it is in pressure control mode.
To return to flow control mode, turn power switch OFF for approximately 45 seconds.
psi
ti15695a | ti15692a |
ti15691a
NOTE: To see the number of blocked signals, press and hold the DTS button.
3A0245B | 9 |