
Customizing and Painting
Painting the Speaker Frame |
| Painting the Speaker Grill |
|
|
|
|
|
|
Figure 12.. Painting the speaker frame. | Figure 13.. Painting the speaker grill. |
NOTE: The Helos 10 can be either painted in place or removed from the ceiling for painting.
IMPORTANT! Do not paint the rear of the speaker or the surface behind the grill.
1Remove the grill from the Helos 10 (see figure 12).
2Press the paint shield into place (see figure 12).
3In a well ventilated area paint the Helos 10 speaker frame, allowing frame to dry completely between coats.
Figure 14.. Removing the logo badge.
IMPORTANT! The grill must be removed from the speaker before painting.
IMPORTANT! The scrim must be removed before painting the grill.
IMPORTANT! The logo badge must be removed before painting the grill.
1Remove the grill from the Helos 10 (see figure 13).
2Remove the logo badge (see below).
3A protective scrim is attached to the back of the grill with
4Paint the grill being careful not to plug the holes. For best results use a spray rather than a brush. Allow paint to completely dry before proceeding.
5Gently press the scrim and logo badge back into place before reinstalling the speaker grill.
Removing the Logo Badge
The MartinLogan logo badge on the Helos 10 is remov- able. To do this, gently depress the tabs on the back of the logo badge (see figure 14).
Customizing and Painting