ETI Sound Systems, INC Matrix 1000 V2 manual Mono SET-UP, Stereo SET-UP, Mixer Sound Source

			Setting Up Your MATRIX 1000 V2 Speaker System
	The MATRIX 1000 consists of one subwoofer and two 10” two-way speakers. Connect the right and left signals from
your mixer (master left/right, line out) to the balanced input sockets of the MATRIX 1000 using standard XLR cables.
				MONO SET-UP						SETTINGS
										Left & Right Gain Controls: After turning on
										your MATRIX 1000 using the on/off switch
										located on the rear amplifier plate of the
						Mixer /
										active subwoofer, set the LEFT and RIGHT
					Sound Source					Gain controls to the center position (or facing
										straight up). This is the ideal position to oper-
										ate the MATRIX 1000 if you have connected
										a mixer to the system. Alternatively, if you
										have connected a CD Player or other sound
										source, it is recommend that the Gain con-
		B-52						B-52
		PROFESSIONAL
								PROFES SIONAL
										trols are turned all the way clockwise to
										achieve peak volume.
			LEFT				RIGHT			During performance, if your MATRIX
										1000 shows signs of distortion, check the
										sound source and, if applicable, reduce the
										sound levels. If it is not possible to reduce the
	to left 10”							to right 10”
										sound levels at the source, simply turn down
	two-way								two-way	the gain levels on the rear amplifier panel of
										the MATRIX 1000.

Caution: The Left and Right 10” two-way outputs are designed for a nominal impedance of 4 ohms. Under no circumstance may the impedance dip below the value as this might damage the MATRIX 1000 amplifier.

SETTINGS

Subwoofer Level Control: It is recommended

STEREO SET-UP

to set the Subwoofer Gain control to halfway. At this position – and with the 10” Two-way speakers set in a similar position – the MATRIX 1000 should be perfectly balanced. If you wish to add bass, simply turn up the Subwoofer Gain control.

Ground Lift Switch: At times you may experi- ence a low-frequency hum. At this time, engage the ground lift switch to eliminate this hum. If this does not eliminate the hum, please check cabling and sound sources.

B-52

PROFESSIONAL

LEFT

to left 10”

two-way

Mixer /

Sound Source

B-52

PROFES SIONAL

RIGHT

to right 10”

two-way

6

CAUTION: Connect the power cable only after you have absolutely made sure that the local mains voltage matches the voltage specified on the device. If you connect to the wrong voltage, you may destroy the electronic com- ponents of the MATRIX 1000 system.