Directed Video OHD1040 manual Operating the Monitor, Power Up/Down the Display Monitor

Operating the Monitor

OPEN/CLOSE THE DISPLAY MONITOR

To open the display monitor, push the "OPEN" latch and pull the monitor down to the desired position.

To close the display monitor, push the monitor up until it latches closed with an audible click.

Power Up/Down the Display Monitor

The unit will power up when the display monitor is unlatched and pulled down. (If the unit does not power up, press the Power button on either the remote or on the left side of the LCD screen.

To turn the power Off to the unit, press the POWER button on the remote three times. Also the power will shut Off when the display monitor is placed in the closed and latched position.

If the icon displays in the upper left-hand corner of the screen when using the remote, it indicates that the command issued is not allowed during the mode that the monitor display is presently in, or is not available on this system.

SIGNAL SOURCE (MODE)

Press remote (MODE) button to select the input signal AV1, AV2 or DVD.

FUNCTION MODE (MENU)

Press remote "VIDEO MENU" button or monitor "MENU" sequence as follows:

button to activate the screen set up

COLOR → CONTRAST		→ BRIGHTNESS → TINT
	RESET
COLOR: Color adjustment		BRIGHTNESS: Brightness adjustment
CONTRAST: Contrast adjustment		TINT: Adjustment to color saturation

RESET: Resets COLOR, CONTRAST, BRIGHTNESS, and TINT to factory settings.

Once the desired setting is selected, press the cursor key to the desired setting. If a key is not acti- vated within 5 seconds, this function mode will turn OFF. Once the correct function is selected, press the cursor key (or the desired setting). If no key is depressed, this function mode will turn OFF in about 5 seconds.

14 © 2004 Directed Electronics, Inc.