CyberHome Entertainment CHLDV712 owner manual Component Video & Progressive Scan Connections

Component Video & Progressive Scan Connections

3Connecting to a TV with Component Video Inputs

Component Video separates the Video Signal into three separate “components”, resulting in a higher quality picture than S-Video or Standard Composite Video. In order to use Component Video, you must use a TV equipped with Component Video Inputs. You’ll also need (3) Component Video Cables (included).

Component Video

Connectors

VIDEO

Step 1: Enter the Setup Menu to Change the Video Setting

With disc play stopped, press the SETUP button on the Remote Control to enter the DVD Player’s On-Screen Setup Menu. Use the ARROW keys to navigate down to the VIDEO menu and press ENTER or Right Arrow Key. Use the ARROW keys again to proceed down to the OUTPUT setting. Press ENTER and then use the UP/DOWN keys to select YCbCr. Press ENTER to confirm your choice.

For Help on Using the Setup Menu, see pg 38.

SYSTEM	NTSC
LANG.	4:3 PS
ASPECT
VIDEO	YCbCr
OUT PUT
AUDIO
CHILD
OTHERS
EXIT

ENTER RETURN SETUP

Step 2: Connect the Player using the Component Video Cables

At this point, connect the separate Component Video Cables to the appropriate jacks.

Normally, cables and jacks are color-coded to make connection easier. Power on TV and set your TV to the Video In Channel associated with the Component Video inputs (“Video 3”, “Input 3”, etc.) Lastly, press the MONITOR button on the DVD player or Remote to switch the video mode to EXTERNAL MONITOR. You should now see the DVD Player splash screen on your TV.

TV

PROGRESSIVE SCAN /

COMPONENT VIDEO IN

Y

Cb Cr

GREEN OR YELLOW

BLUE

RED

DVD

Step 3: If You Are Using a PROGRESSIVE SCAN TV

Now that you are using the Component Video Outputs, you can change the OUTPUT setting to enable Progressive Scan mode. Do not change these settings if you are not SURE your TV supports Progressive Scan.

Using the ARROW and ENTER keys, change the OUTPUT setting to YPbPr. The DVD Player is now in Progressive Scan mode. Exit the setup menu by pressing the SETUP button.

	SYSTEM	NTSC
LANG.
	ASPECT	4:3 PS
VIDEO
	OUT PUT	YPbPr
AUDIO
CHILD
OTHERS
EXIT

Quick Tips

If you need to reset the Player’s Video Settings to factory defaults, Reset the player, Open the Disc Cover and press “STOP - 2 - 0 - 0 - 2” on the Remote Control.

ENTER RETURN SETUP

For Help on Using the Setup Menu, see pg 38.

18