Jensen JCR-540 operating instructions Radio Reception, Using Headphones, CD Programmed Play

Page 7

CD PROGRAMMED PLAY

This function allows your favorite tracks to be played in a programmed sequence.

1.Set the Function Selector to the “CD” position and press the Button to turn the unit on.

2.Open the CD Door, insert a CD and wait until the total number of tracks on the CD is displayed.

3.Press the PROG Button once. Program No, “01”, will be shown briefly and then changes to Track No. “00” and flash together with the Program Indicator, “PROG”, in the Display.

4. Press the

Buttons to select the song to be programmed.

5.Press the PROG Button again to store your selection. Program No. “02” will be shown briefly and resume to “00” and flash to prompt for another input.

6. Press the Buttons to select the next song to be programmed and press the Program Button again to store your second selection.

7.You may repeat steps #3 - #5 to program as many as 20 tracks. If you attempt to program more than 20 tracks, the Display will display flashing “01”.

8.To check the programmed tracks, press the PROG Button repeatedly. The Display will first show the PROGRAM No. and then the programmed track number in the programmed sequence.

9.Press Button to start programmed play.

!After all the programmed tracks have been played the player stops but the program remains in the memory.

!Press the PROG Button and then the Button to begin programmed playback again.

10. To resume normal playback, in “STOP” mode press the

Button.

11.To stop playing, press the STOP Button.

12.To turn the Player off, press the “OFF” Button. The POWER Indicator goes off.

IMPORTANT

Always turn off the power when the unit is not in use in order to extend the battery life.

RADIO RECEPTION

1.Set the Function Selector to “RADIO” and set BAND Selector (# 14) to “AM” or “FM” for the desired radio band.

2.Press the Button to turn unit on. The POWER Indicator lights up.

3.Turn the TUNING Control to obtain the desired radio station.

4.Adjust the VOLUME Control to obtain the desired sound level.

5.When you wish to turn off the Radio, press the “OFF” Button. The POWER Indicator goes off.

TIPS FOR BEST RADIO RECEPTION

The unit has built-in FM and AM antenna. To obtain the best reception, you may have to move or slightly rotate the unit.

USING HEADPHONES

Inserting the plug of your headphones (not included) into the HEADPHONE Jack will enable you to listen to the CD or Radio in private. When using headphones, the Speakers will be disconnected automatically.

READ THIS IMPORTANT INFORMATION BEFORE USING YOUR HEADPHONES

1.Avoid extended play at very high volume as it may impair your hearing.

2.If you experience ringing in your ears, reduce the volume or shut off your unit.

3.Do not use while driving a motorized vehicle. This is dangerous and also illegal in some states.

4.Keep the volume at a reasonable level even if your headset is an open-air type designed to allow you to hear outside sounds. Please note excessively high volume may still block outside sounds.

E-7

Image 7
Contents AM/FM Stereo Shower CD Alarm Clock Radio Compliance with FCC Regulations On Protection Against Laser Energy ExposureUsing the Desk Stand InstallationUsing the Stand Placement of Your RadioFunctions and Controls FM Stereo LED IndicatorAC Operation Power SourceBattery Operation Battery CareCD Player Operation Time SettingTips for Best Radio Reception Using HeadphonesRadio Reception CD Programmed PlayWake to Buzzer Alarm OperationSnooze Alarm Wake to RadioCare and Maintenance Tips on Using Your FOG-RESISTANT MirrorService Troubleshooting Guide