Jensen JIMS-70I Clock Display Unit, Getting Started, To install the batteries proceed as follows

8.Snooze/Sleep/Dimmer Button

9.iPod/iPhone SKIP Forward ; Radio TUNE+ Button; Clock Adjust Forward; Memory Up

10.Volume Up (+) / Alarm1 Set Button

11.Volume Down (-) / Alarm2 Set Button

12.iPod/iPhone SKIP Backward ; Radio TUNE- Button; Clock Adjust Backward; Memory Down

13.AUX-IN Jack

CLOCK DISPLAY UNIT

AL1: Icon lights when Alarm 1 is on.

AL2: Icon lights when Alarm 2 is on.

PM: PM time indicator

GETTING STARTED

This JiMS-70i is designed to operate using the included AC Adaptor. 2 x 1.5V, ‘AAA’ batteries (not included) are also required for the clock, radio preset and alarm memory back up.

To install the batteries proceed as follows

1.Open the battery door located on the bottom of the cabinet.

2.Insert two new batteries (not included) into the compartment following the + and - markings inside the compartment and close the battery door.

WARNING:

DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE.

Note: Use a well-known brand of battery for longer life and best performance.

5