Dynamic Bass Boost system, Maintenance and care

“Dynamic Bass Boost” system

∙The built in "super bass booster" circuit provides a powerful enhancement to low frequency music, giving a stronger bass sound which is ideal for "rock" or "jazz" music.

∙For increased bass at all volume levels, set the DBBS switch into On position for an emphasized bass sound.

Maintenance and care

∙ Check your batteries regularly, old or discharged batteries should be replaced. If the unit is not going to be used for some time or is being run exclusively on the alternative power, remove the batteries to avoid leakage and damage.

∙ Electronic products of this kind should never be subjected to moisture or extreme temperatures.

∙If necessary, clean the unit with a piece of cloth dampened with water only (be sure the AC power cord is disconnected from

the power supply).

∙The heads and capstan are in constant contact with the moving tape. Use a small cotton bud with alcohol or special tape head cleaner to clean these parts. Never touch the heads with anything metallic.

Erase protection

∙To prevent accidental erasing of a cassette, simply break off the two plastic tabs located on the cassette tapes rear side.

∙When a cassette with removed plastic tabs is inserted, the recording button cannot be pressed.

∙If a cassette is to be erased and re-recorded at a later stage, simply cover the holes on the cassette where the tabs were removed, with a piece of strong adhesive tape.

CD protection

∙When pick up the CD disc, always hold the edge of the disc, never touch the surface of the disc, it would scratch the disc surface and may occur sound distortion or raise reading problem.

Specification

Power supply	220 V, 50 Hz

RMS	3.5 W x 2

Net / Gross Weight	2.75 kg / 3 kg

Gift box dimension (L x W x H)	305 mm x 295 mm x 195 mm