Cassette tape recording, Recording from radio

∙When the tape plays to the end, playing will be stopped automatically and releases the PLAY button at the same time.

∙Press the "STOP" button followed by the "REWIND" or "FAST-FORWARD" button to rewind or forward the tape at high speed.

Cassette tape recording

∙Open the cassette door by pressing the "STOP/EJECT" cassette Button.

∙Insert a blank cassette with the tape-side up, into the proper Guide-rails on the inside of the cassette door.

∙Gently push the cassette door forward (inwards) to close it.

∙Make sure the tape is fully and properly inserted before doing so.

∙The set is now ready to start recording, which can be done from either the radio or CD-player.

Recording from radio

∙Set the FUNCTION switch to RADIO position.

∙Tune to the desired station.

∙Press the PLAY button and RECORD button on deck simultaneously to start recording.

Recording from CD

∙Set FUNCTION switch to CD position.

∙Press RECORD and PLAY buttons simultaneously to start recording.

∙Press the PAUSE button.

∙Start the CD-player and select the exact song to be recorded.

∙Release the PAUSE button to start recording.

Insertion & removal of discs

∙When opening the CD-door, always ensure the disc is not in motion (not spinning) when you open the CD-door. Always press "STOP" button to stop the disc spinning first.

∙Place a CD into the compartment with the label-side (printed side of disc) facing upwards. Press down in the center part of disc until the disc "locks" onto the center spindle.

∙When the CD has been placed onto the center spindle, gently lower the CD-door downwards until it locks shut.

∙The CD is now ready to be played.

∙To remove a disc, follow the same procedure as described above, except to remove the CD instead of inserting it into the compartment, by placing one finger at the middle of disc (center spindle) & the other at the edge of the disc & gently pulling upwards.

∙Important : always hold a CD by its edges. Avoid getting any finger prints, smudges or dirt onto the surface of a disc. In case this happens, use a special CD-cleaning cloth or cleaning kit to remove the dirt or smudges.