Wave your hand over the IR SENSOR (#16) to show the indoor temperature
Wave your hand over the IR SENSOR (#16) again within 1 second to show the radio frequency
Wave your hand over the IR SENSOR (#16) again within 1 second to show the ALARM1 time
Wave your hand over the IR SENSOR (#16) again within 1 second to show the ALARM 2 time
5.In radio off mode, with the Display Dimmer Switch set to “AUTO OFF”, the time display will automatically turn off in 15 seconds. Use the IR Sensor to turn it on again:
- Wave your hand over the IR SENSOR (#16) to turn the display on.
DIMMER CONTROL
The display DIMMER SWITCH (#12) is located on the back of the unit. Select either AUTO/HIGH/LOW to change the brightness of the LED DISPLAY (#10).
NIGHT LIGHT
The night light can be turned on or off using the LIGHT ON/OFF button located on the back of the unit.
RESETTING THE UNIT
After you have installed the backup batteries and connect the unit to an AC power source for the first time, we recommend you to press the RESET Button (#11) located on the bottom of the unit to correctly initialize it.
In case of an erroneous display or prolonged abnormal behavior during normal use, you can also safely restore the unit to its factory preset condition by pressing the RESET Button (#11). Please note that all personal settings including current time, alarm time and sleep session will be cleared and will need to be reset, so be sure to set up the clock again according to previous sections above.
Note: In very rare instances, such as an electrostatic discharge on a dry cold winter day, if the unit still fails to reset after pressing the RESET Button, you should unplug it from the AC power source and then remove the backup batteries from the battery compartment at the bottom of