Jensen JCR-208 instruction manual Operating Instructions, Setting the Clock, Dimmer Operation

OPERATING INSTRUCTIONS

SETTING THE CLOCK

When you connect the radio to an AC outlet for the first time the clock display will begin flashing "12:00". The flashing will stop when you set the time.

1.Press and hold the TIME button and repeatedly press the HOUR button to set the correct Hour.

2.Press and hold the TIME button and repeatedly press the MINUTE button to set the correct Minute.

AUTO INDICATOR

PM INDICATOR

NOTE

There is a PM INDICATOR located in the top left-hand corner of the clock display. Be sure to observe the PM indicator when setting the time to make sure the time is set correctly for AM or PM. If the PM indicator is 'On', the time displayed is "PM". If the PM indicator is 'Off, the time displayed is "AM ".

DIMMER OPERATION

Set the Dimmer to Hi for bright illumination and LO for the dark illumination.

LISTENING TO THE RADIO

1.Set the BAND SELECTOR to the desired band, AM or FM.

2.Slide the FUNCTION SELECTOR to the “ON” position.

3.Select your desired station with the TUNING CONTROL.

4.Adjust the VOLUME CONTROL to the desired listening level.

5.When you have finished listening, slide the FUNCTION SELECTOR to the “OFF” position to turn the radio off.

TIPS FOR BEST RADIO RECEPTION

AM - The AM antenna is built inside the radio. If AM reception is weak, change the position of the unit until the internal antenna picks up the strongest signal.

FM - If FM reception is weak, fully extend the wire antenna and vary the position and location of the antenna until you find the strongest signal.

6