EFJohnson 8500 manual Intrinsically Safe Classification, Transceiver Service

Page 42

INTRINSICALLY SAFE CLASSIFICATION

Transceiver Service

If the transceiver is not operating properly, “SYN ERR” or “PROG ERR” may be displayed. It is also possible that all segments of the display are indicated when power is turned on. To attempt to clear this condition, turn the power off and then on again to reset the control logic. Also make sure that the battery is charged, the controls are properly set, and the antenna is tight. If the transceiver still does not operate properly, contact your system operator for service.

NOTE: There are no user-serviceable components in this transceiver. Altering internal adjustments can void the warranty and cause illegal emissions, and result in improper operation that can seriously damage the transceiver.

INTRINSICALLY SAFE

CLASSIFICATION

Introduction

“Intrinsically Safe” is a fire safety rating given to this transceiver by the Factory Mutual Research Corporation. When equipment is given this rating, it is considered safe to use in certain flammable or combustible atmospheres. Flammable atmospheres have been categorized by Class, Division, and Group as described in the next two sections. The specific hazardous atmospheres in which this transceiver has been approved to operate are as follows. This information is also listed on the label on the back of the transceiver.

Intrinsically Safe - Class I and II, Division 1, Groups C, D, E, F, and G. Non-Incendive - Class I, Division 2, Groups A, B, C, and D. Temperature Code - T3C (Battery Pack P.N. 587-8565-162).

42

Page 41 Page 43
Image 42
Page 41 Page 43
Contents Series Safety Information Battery Recycling Information Page Quick Reference Guide Page Table of Contents Operation with Optional Remote Control Unit Controls Front Panel ControlsControls Optional Keys for Telephone Calls Display Information Front Panel DisplayDisplay Information Placing a Standard Call Standard CallsIntroduction Receiving a Standard CallSpecial Calls Placing a Special CallReceiving a Special Call Additional Phone Mode Information Landside-Originated CallsDialing The Number Supervisory Tones Intercept ToneClear-To-Talk Tone Key Press ToneConfirmation Tone End Call Tone System ScanCall Proceed Tone Proceed Dialing ToneScan Resume Delay Transmitting In ScanSystem and Group Lockout Scanning Conventional Systems Other FeaturesScanning Multi-Net Systems Clear-To-TalkTime-Out Timer Group ScanCall Indicator RTN Return KeyEmergency Button Keypad Disable Transmit InhibitPriority Calls Key Press Tone Disable High/Low Power SelectSupervisory Tones MULTI-NET and Conventional ModesChannel Monitoring Group SelectConventional Mode Operation Transmit Disable When BusyMonitoring Before Transmitting Receive-Only and Talk-Around Channels Call Guard SquelchOperation with Optional Remote Control Unit Control Unit Controls Miscellaneous Operating Information Operation with Optional Remote Control Unit Miscellaneous Information Sending Status InformationAuto-Registration Busy Queuing System Operator ProgrammingSetting Volume Level Display MessagesRechargeable Battery Pack Battery PackTransceiver Speaking Into Microphone Operation At Extended RangeFCC Licensing Transceiver Service Intrinsically Safe ClassificationClassification of Areas Division Classification of Atmospheres Class/ GroupApproved
Top Page Image Contents