EFJohnson 8500 manual Other Features, Scanning Multi-Net Systems, Scanning Conventional Systems

Page 24

OTHER FEATURES

System lockout is not available if you have only one selectable system, and group lockout is available only if the selected system is programmed for group scan (see page 25). The lockout status of all systems and groups is maintained when power is turned off.

Scanning Multi-Net Systems

NOTE: For information on Multi-Net and conventional systems, refer to page 29.

When Multi-Net systems are scanned, calls are received on all selectable groups if Group Scan is programmed, and on only the last- selected group if it is not programmed. Your transceiver may also be programmed with fixed groups. Calls on these groups are normally received regardless of system and group scanning.

Scanning Conventional Systems

Group scan is not available with conventional systems. Therefore, calls are received on only the last-selected group of conventional systems. For example, if Groups 1-4 are programmed in a conventional system and Group 2 is the last selected or displayed group in that system, Group 2 is the only group on which calls are received in that system.

If a group is programmed with Call Guard squelch, only messages intended for you will be detected on that group while scanning. However, if Call Guard squelch is not programmed or is disabled by the monitor mode selected by the Auxiliary switch, any message occurring on that group will be heard. Refer to “CONVENTIONAL MODE OPERATION” on page 30 for more information.

OTHER FEATURES

Clear-To-Talk

When a system programmed for Multi-Net operation is selected, a short beep sounds when the push-to-talk switch is pressed. This tone indi-

24

Image 24
Contents Series Safety Information Battery Recycling Information Page Quick Reference Guide Page Table of Contents Operation with Optional Remote Control Unit Controls Front Panel ControlsControls Optional Keys for Telephone Calls Display Information Front Panel DisplayDisplay Information Standard Calls IntroductionPlacing a Standard Call Receiving a Standard CallSpecial Calls Placing a Special CallReceiving a Special Call Additional Phone Mode Information Landside-Originated CallsDialing The Number Supervisory Tones Intercept ToneClear-To-Talk Tone Key Press ToneConfirmation Tone System Scan Call Proceed ToneEnd Call Tone Proceed Dialing ToneScan Resume Delay Transmitting In ScanSystem and Group Lockout Other Features Scanning Multi-Net SystemsScanning Conventional Systems Clear-To-TalkTime-Out Timer Group ScanCall Indicator RTN Return KeyEmergency Button Keypad Disable Transmit InhibitPriority Calls Key Press Tone Disable High/Low Power SelectMULTI-NET and Conventional Modes Channel MonitoringSupervisory Tones Group SelectConventional Mode Operation Transmit Disable When BusyMonitoring Before Transmitting Receive-Only and Talk-Around Channels Call Guard SquelchOperation with Optional Remote Control Unit Control Unit Controls Miscellaneous Operating Information Operation with Optional Remote Control Unit Miscellaneous Information Sending Status InformationAuto-Registration Busy Queuing System Operator ProgrammingSetting Volume Level Display MessagesRechargeable Battery Pack Battery PackTransceiver Speaking Into Microphone Operation At Extended RangeFCC Licensing Transceiver Service Intrinsically Safe ClassificationClassification of Areas Division Classification of Atmospheres Class/ GroupApproved