Setting Up
Unpack the carton (see Figure 1)
Carefully unpack the carton. Do not attempt to use the Wave® radio if any part appears dam- aged. Instead, repack the carton and notify Bose® or your authorized Bose dealer immediately.
Place the Wave® radio on a table or other flat surface. Locate the FM and AM antennas, the power cord, and the AA batteries.
Wave® |
| AA batteries |
radio |
|
|
|
| Remote control |
Power cord | Lithium |
|
| battery |
|
FM antenna |
| |
|
| |
| stick tape |
|
| AM antenna clip | AM loop antenna |
Figure 1
What comes with your Wave® radio.
•One (1) Wave® radio
•One (1) power cord
•Three (3) AA batteries
•One (1) FM antenna
•One (1) AM antenna
•One (1) AM antenna clip
•One (1)
•One (1) remote control
•One (1) lithium battery
Install the batteries
The Wave® radio’s three AA batteries maintain its memory and backup alarm system for up to a week during a power failure, or while the radio is unplugged. The batteries will not power the radio or light the display. Operating without batteries leaves the memory unprotected, but will not harm the radio. Use only 1.5V AA alkaline batteries
1. Carefully turn your Wave® radio | + – + |
upside down (avoid scratching | |
its top). |
|
2.Locate the battery compart-
ment on the bottom (see Figure 2).
3.Press the arrow on the cover to
slide the compartment open.
Figure 2
Match the + and – symbols on the batteries to the marks inside the compartment.
4.Place the batteries inside, matching the + and – symbols with the symbols inside the compartment.
5.Slide the cover back into place and turn the radio right side up.
172087 50W
OUT VARIABLE | |
| IN AUX |
L | R |
AM149204_02_V.pdf | January 7, 2002 | 5 |