Bose Wave Radio manual Connect the power cord and antennas, Clip

Page 6

Setting Up

Connect the power cord and antennas

Find the jacks on the back of your radio (see Figure 3). Unwind all cords.

Connect the power cord

1.Plug the small end of the power cord into the power jack.

2.Plug the other end of the power cord into an electric outlet. The display panel should light up.

Note:

The time display will begin to flash after power is connected. Press the CLOCK SET key once to stop the flashing.

Connect the antennas

1. Plug the FM antenna into the “FM 75External” connector.

2.Plug the AM antenna into the “AM LOOP” jack.

3.Straighten both antennas. Move the AM loop and ends of the FM antenna as far as possible away from the radio.

4.Use the clip and peel-and-stick tape to attach the AM loop antenna to a smooth, clean surface, if you wish.

Note:

A second FM antenna is built into the power cord. For best reception, adjust the antenna by moving the power cord.

R

L

 

AUX IN

 

 

 

120V~AC

AM

 

50-60HZ 50W

 

172087

LOOP

VARIABLE OUT

 

 

 

 

Peel-and-

 

 

stick tape

 

 

clip

Figure 3

Plug the antennas and power cord into their jacks.

6

January 7, 2002

AM149204_02_V.pdf

Image 6
Contents Bose Wave Radio Please read this owner’s guide AvisFor your safety Where to find Install the batteries Unpack the carton see FigureConnect the power cord and antennas Plug the antennas and power cord into their jacksClip Remote control Insert the battery, matching the + symbolsHow to read the clock display How to read the radio displayHow to customize the display Radio functions Release when set Press TIME. The Alarm indicator will flash Clock functionsPress Time to return display to current time Set the alarm to go off. When alarm sounds Time, not alarm timeWhen the alarm goes off the radio volume will Press once. The indicators remain lit,Using other components Selecting the componentCustomer service Limited warrantyMaintaining the Wave radio Features WarrantySize Product Information