The stereo is factory set to display the clock as a default. Follow these steps to change the default display:
1.Turn the stereo off and leave the vehicle's ignition on.
2.Hold down DISP for about 2 seconds. The digits on the display flash.
3.Within 5 seconds, press 2 RPT until the desired display - FRE (Frequency) or CLK (Clock) - appears.
Adjusting the Sound
When you listen to your stereo, adjust these controls to suit your listening preferences.
Preset EQ (Equalizer) - Repeatedly press EQ to select the desired EQ setting: FLAT, JAZ (Jazz), POP, CLAS (Classical), ROCK, VOCAL, or BT (Bass/Treble - EQ Off).
Note: The Bass and Treble controls are bypassed in any EQ mode except EQ Off.
Volume - Repeatedly press (or hold down) + or - to increase or decrease the volume. VOL and a volume level number (0 - 40) appear.
WARNING: To protect your hearing, do not listen at high volume levels. Slowly increase the volume to a comfortable listening level.
Audio Control - Repeatedly press SEL/LD until BAS (Bass), TRE (Treble), BAL (Balance), or FAD (Fader) and a number appear on the display. Then, within 5 seconds, repeatedly press (or hold down) + or - to change the stereo's setting.
Notes: When you adjust the balance toward the left speakers, L and a number
When you adjust the fader toward the front speakers, F and a number
If BAS, TRE, BAL, or FAD and the number disappear before you press
+or
Loudness - To enhance bass sounds, hold down SEL/LD until LOUD appears.