terminal.
Connecting the Antenna
Connect the vehicle's antenna cable to the antenna jack on the back of the stereo.
Completing and Testing the Connections
Make sure you have securely made all other connections, then plug the harness' connector into the stereo's
Install your stereo's control panel (see "Installing the Control Panel") and turn on your vehicle's ignition, the stereo's clock display light, then press PWR.
If the stereo does not work, immediately disconnect the cable from your vehicle's negative
After you verify that the buttons/display light, follow the instructions in "Mounting the Stereo" below.
CAUTION: If you played a CD while testing the connections, be sure to remove the CD from the stereo before continuing.
Using the Control Panel
The stereo's control panel must be installed for the stereo to operate. When you remove it, the stereo will not operate. This is a simple but effective security measure. Any stored stations remain in memory when the control panel is removed.
Installing the Control Panel
1.Insert the left edge of the control panel into the left edge of the recess. The hole in the control panel interlocks with the tab in the recess.
2.Gently push the right edge of the control panel into the recess until you hear a click.
Removing the Control Panel
1.Press REL on the right side of the control panel. The control panel swings out.