Uniden uh049sx-2 owner manual Call Tone, Room Monitor can be temporarily disabled by pressing or

Page 22

UNIDEN Model uh049sx UHF CB Radio

OPERATION

Room Monitor can be temporarily disabled by pressing or.

If no further operation is performed for 45 seconds then the temporary disable mode ends and Room Monitor mode re-activates.

1.Press MENUENT six times.

2.Press or to select desired setting.

The 5 Room Monitor levels are from 1 (High sensitivity) to 4 (Low sensitivity) and Off.

3.Press and hold MENU to save and exit.

ENT

If using this feature as Baby Monitor please note it is not a replacement for regularly checking the safety and security of children.

The operating time is limited to the remaining charge of the battery and is not suitable for continuous overnight use.

If there is any input at EXT SP MIC JACK, Room Monitor automatically turns off.

CALL TONE

Your uh049sx radio is equipped with 5 selectable call tones that will be transmitted

when is pressed momentarily.

1.Press MENUENT seven times. The current call tone setting flashes.

2.Press or to select desired setting. The 5 call tones are C1, C2, C3, C4 and C5.

3.Press and hold MENU to save and exit.

ENT

Current regulations require calling tones to be restricted to one transmission per minute. If a second transmission is attempted within one minute then an error tone will sound.

21

uh049sx OM.indd Sec1:21

17/8/07 3:01:11 PM

Image 22
Contents Uh049sx uh049sx-2 Uh049sx OM.indd Sec11 17/8/07 30104 PM Contents Features IntroductionControls & Indicators Microphone Up Button Down Button Speaker Optional Accessories Included in Your Uh049sx PackTo install the batteries Make sure your radio is OFF Battery InstallationGetting Started Connect the AC adaptor to the charging cradle Battery LifeCharging Batteries Charging TimeLevels Battery Level DisplayBattery 100% full LevelLOW Battery Alert Icon indicates a fully powered unitSetting the Squelch Power ON/OFFVolume OperationTo Transmit and Receive Power of uh049sx is 1 WattSelecting a Channel Press or to select the desired channelTo Operate in Duplex Mode Repeaters Its memory TX Power Low TX Power MiddleTo initiate scanning Example. CH40 becomes active To initiate scanning To deactivate GS scanning, press , orChoosing a Priority Channel Monitor Display when activatedDual Watch To use monitorSelect desired channel CtcssDCS Press or to select Desired Ctcss codeRoom Monitor Current vox setting flashesVOX Press and hold Menu to save ExitRoom Monitor can be temporarily disabled by pressing or Call ToneRoger Beep Busy Channel LockoutKEY Beep Back Lighting Keypad LockTo prevent accidental entries, you can lock Simplex Mode Duplex Mode UHF CB Channels & FrequenciesCtcss & DCS Code List Warranty Warranty only available in original country of purchaseUniden Australia Pty Limited/Uniden New Zealand Limited