Uniden Understanding Busy Channel Lockout for UHF CB Radios

Page 23

UNIDEN Model uh049sx UHF CB Radio

OPERATION

BUSY CHANNEL LOCKOUT

BCL is used when CTCSS or DCS is selected to prevent transmission when the uh049sx detects a transmission from another unit using the same CTCSS or DCS code.

1.Press MENUENT eight times. The current BCL setting flashes.

2.Press or to select desired setting.

3.Press and hold MENU to save and exit.

ENT

ROGER BEEP

Roger Beep is a BEEP that is sent to notify the end of transmission (both PTT and VOX transmission.) Roger Beep can be heard through the speaker when Key Beep is on. Roger Beep is transmitted even if Key Beep is turned off.

However, Roger Beep will not be heard from the speaker.

1.Press MENUENT nine times. The current Roger Beep setting flashes.

2.Press or to select desired setting.

3.Press and hold MENU to save and exit.

ENT

KEY BEEP

Assures the user that the keypad has been properly pressed by emitting a beep tone. This tone can be switched on or off.

1.Press MENUENT ten times. bP setting flashes.

2.Press or to change selection.

3.Press and hold MENU to save and exit.

ENT

22

uh049sx OM.indd Sec1:22

17/8/07 3:01:12 PM

Image 23
Contents Uh049sx uh049sx-2 Uh049sx OM.indd Sec11 17/8/07 30104 PM Contents Introduction FeaturesControls & Indicators Microphone Up Button Down Button Speaker Included in Your Uh049sx Pack Optional AccessoriesGetting Started Battery InstallationTo install the batteries Make sure your radio is OFF Charging Time Battery LifeCharging Batteries Connect the AC adaptor to the charging cradleLevel Battery Level DisplayBattery 100% full LevelsIcon indicates a fully powered unit LOW Battery AlertOperation Power ON/OFFVolume Setting the SquelchPress or to select the desired channel Power of uh049sx is 1 WattSelecting a Channel To Transmit and ReceiveTo Operate in Duplex Mode Repeaters To initiate scanning TX Power Low TX Power MiddleIts memory Example. CH40 becomes active To deactivate GS scanning, press , or To initiate scanningChoosing a Priority Channel To use monitor Display when activatedDual Watch MonitorPress or to select Desired Ctcss code CtcssDCS Select desired channelPress and hold Menu to save Exit Current vox setting flashesVOX Room MonitorCall Tone Room Monitor can be temporarily disabled by pressing orKEY Beep Busy Channel LockoutRoger Beep To prevent accidental entries, you can lock Keypad LockBack Lighting UHF CB Channels & Frequencies Simplex Mode Duplex ModeCtcss & DCS Code List Warranty only available in original country of purchase WarrantyUniden Australia Pty Limited/Uniden New Zealand Limited