Uniden HH955 manual AC Adaptor/Charger, Battery Level Indicator, Belt Clip

AC Adaptor/Charger

!

Make certain, that if you are using rechargeable nickel cadmium batteries in the radio, the switch is set to Ni-Cd. Refer to ‘Batteries’ page 5.

Insert the AC Adaptor power cord connector into the PWR/CHG connection on the side of the radio.

NOTE

The HH955 uses a 15 VDC AC adaptor (NOT a 12 VDC as indicated on the side of the radio).

Plug the other end into an AC power plug. The radio’s power must be OFF to charge the nickel cadmium batteries.

Charge the batteries according to the manufacturers instructions.

As soon as the batteries are charged, disconnect from the power source and radio.

Battery Level Indicator

The battery level indicator will display the current strength of the battery. If the radio is using a large amount of power, such as when transmitting, the indicator will drop and recover when transmitting stops. The battery low warning tone will sound if there is not enough power to operate when transmitting. You may be able to continue by switching to 1 watt transmit power.

Important Points:

1.Do not over-charge - this will shorten the life of your rechargeable nickel cadmium batteries.

2.Use only the AC Adaptor (AAD955S) that comes with the HH955.

3.If Ni-Cad batteries are being used the battery level indicator may not display full, after charging .

Belt Clip

Attach the belt clip with the screws (included).

6