1.The snooze function is activated by pressing any one of the following buttons: “SET”, “IN”, “OUT” or “SNZ”.
2.To turn the alarm off completely, press any of the following buttons: “CH”, “AL1”, “AL2” or “DATE”.
3.The snooze function will last for 5 minutes before the alarm begins to sound again. Either the ((1)) or the ((2)) icon will flash during the snooze mode.
VI. Adding Remote Thermo/hygro Sensors (OPTIONAL)
The
Note: When setting up multiple remote sensors it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the remote sensors. Second install batteries into the indoor weather station. Transmission problems will arise if this is not done correctly and if the total time for
A.Set-up of Multiple Units
1.It is necessary to remove the batteries from all units currently in operation.
2.Remove the battery covers to all remote sensors.
3.Place all remote sensors in a numeric sequential order.
4.In sequential order, install batteries following the same battery installation procedures seen in Detailed
5.Install batteries into the indoor weather station.
6.Follow the Detailed
18